Cherry Audio Forums

Okay, that makes sense and thanks for the toggle.

I can only get the last MULT knob to move to 4x with 5 volts sent to the cv input. Is that normal? I can get the DIV knob to move between 1 and 32 using the same 5 volt range. +10 volts doubles the range on the knob, as one would expect. However, that still doesn't cover the whole range. Otherwise, ...

Yes, thank you! It's exactly what I was looking for.

Cheers.
d.

Okay, just noticed something. If the voltage is set above 1V then that knob gets set to 1V after closing and re-opening VM. Knobs set below 1V are not affected. This is consistent every time.

Thanks.
d.

This is easy to reproduce. Create a basic patch using CV Stepper. Adjust the CV knobs. Close VM. Open VM and now the knobs have all shifted to the same value. See attachments. CVStepper1 is the initial patch. CVStepper2 is the patch after closing and re-opening VM. This started happening after upgra...

Okay, will give a go when I get a chance. Thanks again!

It works fine in 2.7. I just double checked. This appears to be a problem with 2.9.2.

Thanks.

Terrific! Thanks.

Yes, that would be great.

Thanks, it's greatly appreciated!

Great, thanks!

d.