Cherry Audio Forums

PM CV Stepper has just been published. It is based on PM Stepper, but it has got some new capabilities and became a complete sequencer now. So it will simplify your setups.

CV Stepper features:
- 1 to 8 steps CV sequencer
- positive, negative or bipolar CV output
- cascadable as PM Stepper, even both types in mixed order up to total 999 steps
- works triggered with audio frequency and can so create wave forms
- both quantized and detuned setup possible at same time
- CV can be limited to +/-5 or +/- 10 volts

CV Stepper is part of bundles P.moon Sequencer Kit and Ultimate Bundle

It is also sold individually, for a while with half price!

At the moment, example presets cannot be downloaded from CA server. You can get them from P.moon website:
https://p-moon-modules.de/presets.htm

Build #5 for P.moon CV Stepper is released.

Many common sequencers go to step 1 when they get reset, while PM CV Stepper goes to step 0, an inactiv state. Now user can preselect CV Stepper's reset behavior with a small slide switch at reset input jack.

Default is still jump to step 0. So existing user presets will function as before.

Build #6 is released

New in this version:

1. Gate time can now be adjusted in three modes:
- opt (optimum, default, same as in older versions) Gate is ON during whole step time with a one sample interrupt at the beginning of a step.
- trig (trigger pulse) Gate is ON only for 1/48 millisecond (= one sample).
- msec (milliseconds) Gate length is setable from one to 999 milliseconds. Gate will stay ON as long as duration is set, even when following step section/sections is/are toggled OFF. If following sections are ON, their gate signals may get lost.

2. CV limit slider has got removed
Introduced gate duration knob needs same space. So seldom touched CV limit slider disappeared from module front. Now a drop down menu at CV Output has to be used to eventually select a CV limitation.

3. Section controls stay unchanged
- When number of steps gets reduced, highest step section controls get disabled without losing their settings. Depending on section #1 setting (ON or OFF), HOLD state of now highest section may change, according built in logical rules.
- When number of steps increases, HOLD state of both highest and formerly highest step section may change.

Updated CV Stepper manual is downloadable at product page in CA store https://store.cherryaudio.com/modules/cv-stepper and here:https://p-moon-modules.de/docs/cv_stepper_j.pdf