Page 1 of 1
PercusSynth - device does not save the mode
Posted: Tue Nov 28, 2023 8:15 am
by martin17
Unfortunately, VoltageModular does not save the mode of PercusSynth.
It is annoying.
I use an extra blank for this information.
That slows down the workflow.
The problem is certainly not new, but it should finally be fixed.
Re: PercusSynth - device does not save the mode
Posted: Wed Dec 06, 2023 8:56 pm
by Nrgzr78
martin17 wrote: ↑Tue Nov 28, 2023 8:15 am
Unfortunately, VoltageModular does not save the mode of PercusSynth.
It is annoying.
I use an extra blank for this information.
That slows down the workflow.
The problem is certainly not new, but it should finally be fixed.
I already fixed, just waiting for CA approval.
I'll let you know when the update will be ready.
Re: PercusSynth - device does not save the mode
Posted: Tue Dec 12, 2023 11:12 pm
by Nrgzr78
The update has been approved and released.
Re: PercusSynth - device does not save the mode
Posted: Wed Dec 13, 2023 8:26 pm
by martin17
Thank you, but now the two letters A and B have the same functions and the noise is completely missing...
Re: PercusSynth - device does not save the mode
Posted: Thu Dec 14, 2023 10:11 pm
by Nrgzr78
martin17 wrote: ↑Wed Dec 13, 2023 8:26 pm
Thank you, but now the two letters A and B have the same functions and the noise is completely missing...
You're damn right and I fixed it right now. Few days for CA approval and you will be not disappointed this time.
Re: PercusSynth - device does not save the mode
Posted: Mon Dec 18, 2023 8:37 pm
by Nrgzr78
The update is now available.
Re: PercusSynth - device does not save the mode
Posted: Tue Dec 19, 2023 7:20 pm
by martin17
Thank you very much! Now I am very satisfied